Table of Contents
Advertisement
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
compute node with the bezel pointing toward you.
To remove the optional 3.5-inch hard disk drive hardware RAID cage, complete the
following steps.
Screws
Figure 58. Removing a 3.5-inch hard disk drive hardware RAID cage
1. Remove the cover (see "Removing the compute node cover" on page 110).
2. Disconnect the power cable and the mini-SAS cable from the system-board and
the storage tray respectively (see "Cabling hard disk drive with ServeRAID
SAS/SATA controller" on page 181).
3.5-inch Hard disk
drive cage
Chapter 5. Removing and replacing components
139
Advertisement
Table of Contents
Troubleshooting
