IBM NeXtScale nx360 M4 Installation And Service Manual page 197

Battery holder
Left air baffle
1.8-inch solid state drive
2.5-inch Hard
disk drive
Figure 111. Major components of the compute node
Install all of the components in the following list that you removed from the old
compute node onto the new compute node:
v DIMMs (see "Installing a memory module" on page 133).
v Air baffles (see "Replacing the air baffle" on page 114).
v Hard disk drives and hard disk drive fillers (see "Installing a 3.5-inch hard disk
drive" on page 146, "Installing a 2.5-inch hard disk drive" on page 149, and
"Installing a 1.8-inch hard disk drive" on page 152).
v Microprocessors, heat sinks, and microprocessor heat-sink fillers. Use the
microprocessor installation tool that comes with the replacement microprocessor
to remove each microprocessor from the compute node and install each one
immediately in the new compute node (see "Removing a microprocessor and
heat sink" on page 165 and "Replacing a microprocessor and heat sink" on page
168).
v Hard disk drive backplate (see "Installing the hard disk drive backplate" on
page 143).
After you install the compute node, complete the following steps:
1. Install the cover onto the compute node (see "Installing the compute node
cover" on page 111 for instructions).
2. Install the compute node into the chassis (see "Installing a compute node in a
chassis" on page 97 for instructions).
3. If any Features on Demand (FOD) features are installed in the compute node,
see the instructions in the IBM Feature on Demand User's Guide to reactivate
these features. To download this document, go to /http://www.ibm.com/
systems/x/fod/, log in, and click Help.
Cover
1.8-inch solid-state
drive cage
Heatsink
Heatsink
filler
PCI riser cage
3.5-inch Hard
disk drive
Chapter 5. Removing and replacing components
1.8-inch solid state
drive backplate
2.5-inch Hard disk
drive backplate
2.5-inch Hard disk
drive cage
3.5-inch Hard disk
drive cage
Microprocessor
DIMM
Right air baffle
179