IBM NeXtScale nx360 M4 Installation And Service Manual page 204

40000001-00000000 • 40000004-00000000
CIM Information
SNMP Trap ID
Automatically contact Service
User response
The following is the list of Integrated Management Module II (IMM2) error
messages and suggested actions to correct the detected server problems. For more
information about Integrated Management Module II (IMM2), see the Integrated
Management Module II User's Guide at http://www-947.ibm.com/support/entry/
portal/docdisplay?lndocid=migr-5086346.
40000001-00000000 Management Controller [arg1]
Network Initialization Complete.
Explanation: This message is for the use case where a
Management Controller network has completed
initialization.
Severity: Info
Alert Category: System - IMM Network event
Serviceable: No
CIM Information: Prefix: IMM and ID: 0001
SNMP Trap ID: 37
Automatically notify Support: No
User response: Information only; no action is
required.
40000002-00000000 Certificate Authority [arg1] has
detected a [arg2] Certificate Error.
Explanation: This message is for the use case when
there is an error with an SSL Server, SSL Client, or SSL
Trusted CA Certificate.
Severity: Error
Alert Category: System - SSL certification
Serviceable: No
186
IBM NeXtScale nx360 M4 Type 5455: Installation and Service Guide
Provides the prefix of the message ID and the sequence number that is
used by the CIM message registry.
The SNMP trap ID that is found in the SNMP alert management
information base (MIB).
If this field is set to Yes, and you have enabled Electronic Service Agent
(ESA), IBM Support will be notified automatically if the event is generated.
While you wait for IBM Support to call, you can perform the
recommended actions for the event.
Indicates what actions you should perform to solve the event.
Perform the steps listed in this section in the order shown until the
problem is solved. After you perform all of the actions that are described
in this field, if you cannot solve the problem, contact IBM Support.
Note: This list includes error codes and messages that might not apply to
this machine type and model.
CIM Information: Prefix: IMM and ID: 0002
SNMP Trap ID: 22
Automatically notify Support: No
User response: Make sure that the certificate that you
are importing is correct and properly generated.
40000003-00000000 Ethernet Data Rate modified
from [arg1] to [arg2] by user [arg3].
Explanation: This message is for the use case where a
user modifies the Ethernet Port data rate.
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0003
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is
required.
40000004-00000000 Ethernet Duplex setting modified
from [arg1] to [arg2] by user [arg3].
Explanation: This message is for the use case where A
™