IBM NeXtScale nx360 M4 Installation And Service Manual page 125

Table 16. Hard disk drive configuration for storage tray
Legend: HDD=> hard disk drive
HDD 7
quantity
Drive HDD
bay 0
Drive HDD
bay 1
Drive HDD
Internal
bay 2
storage
Drive HDD
node
bay 3
Drive HDD
bay 4
Drive HDD
bay 5
Drive HDD
bay 6
If a hard disk drive fails, it is recommended to keep the failed hard disk drive in
the storage tray until installing a new hard disk drive or a filler.
1. Carefully lay the storage tray on a flat, static-protective surface, orienting the
storage tray with the release latch near your right hand side.
2. Connect the configuration cable, the hardware RAID (signal) cable, and the
mini-SAS cable to the storage tray.
3. Install the easy-swap hard disk drive #6 (see "Installing a 3.5-inch hard disk
drive" on page 146).
4. Orient the storage tray so that the posts on the inside of the storage tray slide
into the slots on the compute node.
Note: Before you install the storage tray, make sure that the air baffles and all
components are installed and seated correctly and that you have not left loose
tools or parts inside the compute node.
6 5 4
HDD HDD HDD
HDD HDD HDD
HDD HDD HDD
HDD HDD HDD
HDD HDD Blank
HDD Blank Blank
Blank Blank Blank
Chapter 5. Removing and replacing components
3 2 1
HDD HDD HDD
HDD HDD Filler
HDD Filler Filler
Filler Filler Filler
Blank Blank Blank
Blank Blank Blank
Blank Blank Blank
0
Filler
Filler
Filler
Filler
Blank
Blank
Blank
107