IBM NeXtScale nx360 M4 Installation And Service Manual page 182

2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
This component can be installed as an optional device or as a CRU. The
installation procedure is the same for the optional device and the CRU.
To install the USB flash drive, complete the following steps.
Figure 92. Installing USB flash drive
1. Remove the cover (see "Removing the compute node cover" on page 110).
2. Locate the USB connector on the system-board (see "System-board internal
3. Push the USB flash drive into the connector.
After you install the USB flash drive, complete the following steps:
164
IBM NeXtScale nx360 M4 Type 5455: Installation and Service Guide
it (see "Removing a compute node from a chassis" on page 96 for instructions).
compute node with the bezel pointing toward you.
connectors" on page 16).
USB hypervisor key