Removing The Hard Disk Drive Cage - IBM NeXtScale nx360 M4 Installation And Service Manual

Figure 36. Installation of the front handle
1. Orient the front handle so that the blue release latch is toward the middle of
the compute node.
2. Align the hole in the handle with the hole on the compute node where the
handle is installed.
3. Using a Phillips screwdriver, install the Phillips #2 screw that secures the
handle. Install the screw that you removed when you removed the handle.
After you install the front handle, install the compute node into the chassis (see
"Installing a compute node in a chassis" on page 97 for instructions).

Removing the hard disk drive cage

Use this information to remove the hard disk drive cage.
Before you remove the hard disk drive cage, complete the following steps:
1. Read "Safety" on page vii and "Installation guidelines" on page 93.
2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove
it (see "Removing a compute node from a chassis" on page 96 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
compute node with the bezel pointing toward you.
To remove the hard disk drive cage, complete the following steps.
Handle
Screw
Chapter 5. Removing and replacing components
121