IBM NeXtScale nx360 M4 Installation And Service Manual page 171

Attention: Static electricity that is released to internal server components when
the server is powered-on might cause the server to halt, which might result in the
loss of data. To avoid this potential problem, always use an electrostatic-discharge
wrist strap or other grounding system when you work inside the server with the
power on.
To install a 1.8-inch hard disk drive, complete the following steps.
1. Read "Safety" on page vii and "Installation guidelines" on page 93.
2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove
it (see "Removing a compute node from a chassis" on page 96 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
compute node with the bezel pointing toward you.
4. Remove the cover (see "Removing the compute node cover" on page 110).
5. Pull the plunger of the 1.8-inch hard disk drive cage outward and rotate the
cage upward.
1.8-inch SSD cage
2
Figure 76. Lift the 1.8-inch hard disk drive cage upward
6. Remove the filler panel, if one is present.
7. Touch the static-protective package that contains the disk drive to any
unpainted metal surface on the server; then, remove the disk drive from the
package.
8. Make sure that the tray handle is open; then, carefully slide the drive into the
drive bay until the drive snaps into place.
1.8-inch SSD
Figure 77. 1.8-inch hard disk drive installation
9. Pull the plunger of the 1.8-inch hard disk drive cage outward and rotate the
cage downward until the cage snaps into place.
1
Chapter 5. Removing and replacing components
153