Installing the compute node
Use this information to install the compute node.
Note: This procedure should be performed only by trained service technicians.
Before you install the compute node, complete the following steps:
1. Read "Safety" on page vii and "Installation guidelines" on page 93.
2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
4. Obtain the following for use during the replacement procedure (see Chapter 4,
Important: When you replace the system board, you must update the compute
node with the latest firmware or restore the preexisting firmware. Make sure that
you have the latest firmware or a copy of the preexisting firmware before you
proceed. See "Updating the firmware" on page 21 for more information.
To install the compute node, complete the following steps.
178
IBM NeXtScale nx360 M4 Type 5455: Installation and Service Guide
it (see "Removing a compute node from a chassis" on page 96 for instructions).
compute node with the bezel pointing toward you.
"Parts listing, IBM NeXtScale nx360 M4 Compute Node Type 5455," on page
85).
v Alcohol wipes (part number 59P4739)
v Bezel
v RFID tag (required only if the compute node came with a RFID tag attached
to the bezel)
v T8 torx screwdriver (part number 00FK488, provided on the back of the
chassis)
v Thermal grease kit (part number 41Y9292)