IBM NeXtScale nx360 M4 Installation And Service Manual page 159

Screws
Figure 60. Installing a 3.5-inch hard disk drive hardware RAID cage
1. Remove the cover (see "Removing the compute node cover" on page 110).
2. Position the hardware RAID cage in the bezel at an angle and rotate the cage
into position on the system board.
3. Align the cage with the screw holes on the system board.
4. Using a Phillips screwdriver, insert the 4 screws and secure the cage in the
compute node.
5. Install the easy-swap hard disk drive #7 (see "Installing a 3.5-inch hard disk
drive" on page 146).
6. Connect the power cable and the mini-SAS cable on the system-board and the
storage tray respectively (see "Cabling hard disk drive with ServeRAID
SAS/SATA controller" on page 181).
3.5-inch Hard disk
drive cage
Chapter 5. Removing and replacing components
141