Table of Contents
Advertisement
●
When debugging a program, the input (X) can be set to on or off by the following:
• Device test in GX Developer
• OUT Xn instruction
Figure 9.5 Input (X) on/off with the OUT Xn instruction
●
The input (X) can also be used for the following.
• Refresh target device (CPU module side) of RX in CC-Link
• Refresh target device (CPU module side) of CC-Link IE controller network or MELSECNET/H
ON/OFF command
OUTX1
X1
CHAPTER9 DEVICES
9
2
3
4
5
6
7
8
9 - 7
Advertisement
Table of Contents
