Mitsubishi Electric melsec q00ujcpu User Manual page 328

Item
Device points
Latch (1) start/end
File register
(Latch clear valid)
extended
*6
setting
Latch (2) start/end
(Latch clear invalid)
*4
32 bit Indexing
*1ÅF When changing the device points, new setting must not exceed the refresh ranges of network modules or the auto refresh ranges of
intelligent function modules.
If a new device point setting exceeds the corresponding device range, the data may be written to another device or an error may occur.
*2: When a device latch range is set, the scan time increases.
When latching a device, consider the increase in the scan time. (
*3: The points for the step relay (S) can be changed to 0 if the serial number (first five digits) of the Universal model QCPU is "10042" or later.
*4: Available only when the serial number (first five digits) of the Universal model QCPU is "10042" or later.
*5: For the Q03UDCPU, Q04UDHCPU, Q06UDHCPU, Q13UDHCPU, Q26UDHCPU, Q03UDECPU, Q04UDEHCPU, Q06UDEHCPU,
Q13UDEHCPU, or Q26UDEHCPU, if the serial number (first five digits) is "10101" or earlier, the index register cannot be used as a
local device. ( Section 9.14.2)
*6: Not available for the Q00UJCPU.
Table8.5 Device setting list (continued)
Parameter
Description
No.
Set points for the file register
(ZR), extended data register
2000
H
(D), and extended link register
(W).
Set a latch range (start and
end device numbers), which
2004
H
can be cleared by remote latch
clear operation.
Set a latch range (start and
end device numbers), which
2005
H
cannot be cleared by remote
latch clear operation.
Select Z or ZZ device for 32-bit
2000
H
indexing.
Setting range
Point assignment to the file
register (ZR), extended data
register (D), or extended link
register (W). Assign part of the
points of the file register to the
extended data register and
extended link register.
Each latch range for the file
register (ZR), extended data
register (D), or extended link
register (W).
Each latch range for the file
register (ZR), extended data
register (D), or extended link
register (W).
Z0 to Z18 (when using Z device)
Section 10.1.2)
CHAPTER8 PARAMETERS
Default Reference
Section 9.1,
Blank
9.8
Section 3.4,
Blank
6.3
Section 3.4,
Blank
6.3
QCPU
Programmin
Use Z g Manual
(Common
Instructions)
8 - 8
1
2
3
4
5
6
7
8