Remote Password - Mitsubishi Electric melsec q00ujcpu User Manual

8.3 Remote Password

This section provides the list of parameters for use of remote password and describes parameter details.
A remote password are set for an Ethernet module, serial communication module, modem interface
module, or Built-in Ethernet port QCPU
Item Parameter No.
Password settings
Model
Password
name
active
module
settings
Start XY
Detail
User connection No.
System connection
8 - 25
Figure 8.18 Remote password settings dialog box
.
Table8.20 Remote password setting list
Description
Enter a remote password.
-
Select a model name of the module
for which the remote password set
-
to the CPU module is checked.
Set the start address of the module
for which the remote password is
-
checked.
Set details of the remote password
-
for the QJ71E71.
Select user connection No.
-
Select a valid port of the remote
-
password for system connection.
Setting range
Four characters or less
(alphanumeric characters, special
symbols)
• QnUDE(H)CPU
• QJ71E71
• QJ71C24/CMO
0000 to 0FE0
H H
-
Connection 1 to Connection 16
Specify a valid port of the remote
password.
• Auto open UDP port
• FTP transmission port (TCP/IP)
• GX Developer transmission port
(TCP/IP)
• GX Developer transmission port
(UDP/IP), Dedicated instruction,
CC IE Control, MNET/10(H) relay
transmission port.
• HTTP port
Default Reference
-
• QnUDE(H)CPU:
-
QnUCPU Userís
Manual
(Communication
-
via Built-in
Ethernet Port)
• QJ71E71:
-
Ethernet module
manual
-
• QJ71C24:
Serial
communication
module manual
• QJ71CMO:
Modem interface
-
module manual