Replacing A Dry Ink/Toner Cartridge - Xerox Versant 4100 Press Quick Start Manual

Maintenance
a. At the control panel, press the Tools button.
b. From the screen that displays, select the Tools icon.
c. Select System Settings→Common Service Settings→Maintenance.
d. Use the arrow buttons to access the next Maintenance screens.
e. Select the Technical Key Operator icon.
The Technical Key Operator feature displays.
f. Log in to the Technical Key Operator mode.
Attention
If you cannot log in as TKO or do not have the TKO password, call your Customer Service
Engineer.
g. Select the item that corresponds with the newly-replaced components.
h. Select Reset Current Value. The system resets the High Frequency Service Item (HFSI) to 0.
i. Repeat the previous steps until the counters for all three components are reset to zero (0).
j. Exit administrator mode by pressing the Log In or Out button on the control panel.
When prompted, select Logout.
R R e e p p l l a a c c i i n n g g a a D D r r y y I I n n k k / / T T o o n n e e r r C C a a r r t t r r i i d d g g e e
Note: The dry ink/toner cartridge can be replaced while a job is printing.
1. Open the dry ink/toner cover, located just above the press front door or cover.
2. Lay paper on the floor before removing the cartridge. This will allow any excess dry ink/toner to
fall on the paper.
3. Slowly remove the dry ink/toner cartridge by placing fingers under the end of the cartridge and
gently pulling it straight out. While pulling out, hold the bottom of the cartridge with your other
hand to give it support.
Ensure that you remove the same cartridge that matches the color as indicated in the message.
36 Xerox ® Versant ®
Quick Start Guide
4100 Press