Program Creation with EasyStep and G Code
7.4 Program steps
7.4.5 Program editor
Changing a program step
Copying program steps
into another program
Press the soft key "Recall" to return to the machining sequence
without saving your changes.
Program steps can be deleted, copied and inserted again with the
"Program editor" function.
Press the soft key "Program editor" in PROGRAM mode.
Use the cursor keys to select the step you want to change. Then press
the appropriate soft key:
Deleting a program step
Copying and inserting a program step
Moving a program step
A program step is always inserted after the current program step.
Use the cursor keys to select the first or last program step you want to
change and then press the "Select" soft key. Then, using the cursor
keys, select the rest of the program steps you want to edit.
Deleting program steps
Copying and inserting program steps
Moving program steps
First, copy the steps you want to insert in another program (please
refer to the instructions for selecting and copying).
Then open the program into which the program steps are to be
and select the program editor.
Using the arrow keys, select the block after which the copied blocks
are to be inserted and then press the "Insert" soft key.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition