Display Machining Sequence - Siemens SINUMERIK 840DE Operation & Programming Manual

7
Program Creation with EasyStep and G Code

7.3 Display machining sequence

7.3

Display machining sequence

7-132
Sequence of operations
You can call the EasyStep flow chart from every mode (except for
MANUAL) via the information key.
The machining sequence is displayed with the individual program
steps.
The contour steps contour, stock removal and residual material are
linked in the flow chart via a square bracket next to the machining
symbol.
You can switch between the contour display and the EasyStep flow
chart by activating the "Information" key.
You can navigate in the machining sequence using the following keys:
Move one line up or down.
Page one screen forward or back.
Jump to the beginning or end of the machining sequence.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
7
08.02