Parts Program Management
A file management function is available to you in the following modes:
• G code
• CYCLE (for thread and thread undercut cycles only)
The "Directory" soft key can be found in CONTOUR, PROGRAM and
G code modes in the basic soft key menu; with thread cycles it is in
the extended soft key menu.
The following are possible for the files:
• deleting and
• exporting and importing via the RS-232 interface.
• for thread and thread undercut cycles: Save input parameters in
• in CONTOUR mode: Inserting a stored contour into an EasyStep
An error log informs you whether any errors occurred while the
RS-232 interface was in use.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition