Siemens SINUMERIK 840DE Operation & Programming Manual page 160

9
General Functions
9.1 Simulation and simultaneous recording
Precondition
Simultan-
eous rec.
Dry run
Dry run
feedrate
Precondition
Dry run
9-160
Sequence of operations
Selecting dry run
You have selected the EasyStep machining sequence.
Select the extended soft key menu with the "ETC" key.
Select the soft key labeled "Simultaneous recording".
Select the soft key labeled "Dry run".
If necessary, activate the dry run speed by pressing the soft key "Dry
run feedrate".
Initiate the program dry run by pressing the "NC start" key.
Deselecting dry run
Program is active
Press the "NC Stop" key twice
and
the soft key "Abort"
Deselect the dry run function by pressing the soft key "Dry run".
The control system returns to the state it was in before Dry Run was
selected.
• The dry run function can be selected/deselected provided that no
NC start command is active. The spindle is simulated in the actual-
value display in the dry run.
• You can terminate graphic simulation of a program during NC
operation with the key "Recall".
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
9
08.02