Description Of Alarms - Siemens SINUMERIK 840DE Operation & Programming Manual

11
08.02

11.2.3 Description of alarms

111 001
Explanation
Reaction
Remedy
111 002
Explanation
Reaction
Remedy
111 003
Explanation
Reaction
Remedy
111 004
Explanation
Reaction
Remedy
111 005
Explanation
Reaction
Remedy
111 006
Explanation
Reaction
Remedy
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Non-interpretable step in line %1
%1 = Line number
The step is not an element of ManualTurn.
Alarm display
EasyStep sequence is not loaded
Delete program step or edit program in operating area PROGRAMS of
SINUMERIK 840D or 810D (CNC mode).
Not enough memory
Abort in line %1
%1 = Line number
EasyStep sequence contains too many steps
Alarm display
EasyStep sequence is not loaded
Edit the program in the PROGRAMS operating area of the
SINUMERIK 840D or 810D (CNC mode).
ManualTurn: %1
%1 = Error number
Internal system message via the user interface of ManualTurn
Alarm display
Acknowledge error and inform Siemens.
File does not exist or is incorrect: %1
%1 = Name of the file/contour
EasyStep sequence cannot interpret a step with contour programming.
Contour does not exist in directory.
Alarm display
NC start disable
Load contour in directory.
Error on interpreting the contour %1
%1 = Name of the contour
Contour is incorrect
Alarm display
NC start disable
Check machining sequence of contour
Maximum number of contour elements exceeded %1
%1 = Name of the contour
Max. permissible number of 50 contour elements exceeded during
interpretation of machining sequence of a contour.
Alarm display
Check machining sequence of a contour and correct, if necessary.
Alarms and Messages
11.2 Alarms with ManualTurn
11
11-175