Download  Print this page

Advertisement

6
Turning any Contours (Free Contour Input)
6.5 Create contour elements
Dialog selection
Dialog
selection
Accept
dialog
Change
selection
Notes on entering
contours
6-118
A separate feed can be entered for each element. If not value is
specified, the feed is taken over from the cutting cycle.
You are given a dialog selection if the parameters can belong to two
different contours.
By toggling the soft key, you can display the two possible selections.
The selection you have made is displayed by an unbroken line (white)
and the alternative by a dotted line (green) in the graphic display area.
By selecting the soft key labeled "Accept dialog", you can transfer your
dialog selection to the system.
You can cancel your dialog selection with this soft key. Both options
are displayed again.
If previous input values make further selection superfluous, the dialog
is stopped!
• Straight line/Circle or Chamfer/Radius?
You can use a transition element whenever the two adjoining
elements form an intersection point which can be calculated from
the input values. Otherwise, you must use the contour elements
Straight line/Circle.
• Input value has already been calculated!
If a contour is overdefined, a value to be entered may already have
been calculated from other values.
Problems can result if the dimensions entered are inexact and an
input value which should be precise does not correspond to the
calculated value. In this case, values from which the value to be
entered has been calculated must be deleted again. You can then
enter the precise value.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
6
08.02

Advertisement

   Also See for Siemens SINUMERIK 840DE

Comments to this Manuals

Symbols: 0
Latest comments: