Download  Print this page

Messages In Cycles - Siemens SINUMERIK 840DE Operation & Programming Manual

Hide thumbs

Advertisement

11
08.02
Alarm number
61606
62200

11.1.3 Messages in cycles

© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
11.1 Alarms and messages in ManualTurn cycles
Alarm text
"Error during contour
preparation"
"Start spindle"
The cycles output messages in the dialog line of the control. These
messages do not interrupt processing.
Messages provide you with information about cycle behavior and
processing progress. They are usually retained over a processing
section or until the end of the cycle, e.g. messages about the current
thread during machining as a longitudinal or face thread.
Cycle
Explanation, Remedy
Cutting in
During preparation of the contour an
STOCK
error was detected, this alarm is always
REMOVAL
output with NCK alarm 10930 ... 10934,
15800 or 15810 (see Diagnostics
Guide)
Thread
The spindle must be running before the
thread can be machined.
11
Alarms and Messages
11-173

Advertisement

   Also See for Siemens SINUMERIK 840DE

Comments to this Manuals

Symbols: 0
Latest comments: