Siemens SINUMERIK 840DE Operation & Programming Manual page 10

0
Preface
Basis
Add-on equipment
Personnel
Behavior
Service
0-10
Other functions not described in this documentation might be
executable in the control. This does not, however, represent an
obligation to supply such functions with a new control or when
servicing.
Your SIEMENS 840D/810D with ManualTurn is state of the art and is
manufactured in accordance with recognized safety regulations,
standards and specifications.
Using special add-on equipment and expanded configurations from
SIEMENS, SIEMENS controls can be adapted to suit your specific
application.
Only authorized and reliable personnel with the relevant training
must be allowed to handle the control. Nobody without the necessary
training must be allowed to work on the control, not even for a short
time.
The responsibilities of the personnel employed for setting, operating
and maintenance must be clearly defined and supervised.
Before the control is started up, it must be ensured that the Operator's
Guide has been read and understood by the personnel responsible.
The operating company is also responsible for constantly monitoring
the overall technical state of the control (faults and damage apparent
from the outside and changes in response).
Repairs must only be carried out in accordance with the information
given in the Service and Maintenance Guide by personnel trained
and qualified in the relevant field. The relevant safety regulations
must be observed.
The following is contrary to the intended purpose and exonerates
the manufacturer from any liability:
• Any use whatsoever beyond or deviating from the application
stated in the above points.
•
If the control is not in perfect technical condition, or is operated
without awareness for safety or the dangers involved or without
observing the instructions given in the instruction manual.
•
If faults that can reduce safety are not remedied before the
control is started up.
•
Any modification, overriding or deactivation of equipment on
the control used for the perfect functioning, unrestricted use or
active and passive safety.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
0
08.02