Undercuts Form E And F - Siemens SINUMERIK 840DE Operation & Programming Manual

5
08.02

5.2.4 Undercuts Form E and F

Precondition
Undercut
Form F
Undercut
or
Form E
Undercut
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
5.2 Turning cycles in CYCLE mode
Function
These cycles allow you to machine form E and F undercuts to
DIN 509.
Form F
Special cycles are available (see Section "Thread undercuts") for
machining thread undercuts.
Sequence of operations
CYCLE mode is selected.
Select the soft key labeled "Undercut".
Select the appropriate soft key for the undercut you require.
Turning with Cycles
Form E
5
5-89