Siemens SINUMERIK 840DE Operation & Programming Manual page 144

7
Program Creation with EasyStep and G Code
7.10 G code programming
Copy
block
Delete
block
Insert
block
Delete
NC block
Renumber
Searching the text
Search
Search
Replace
7-144
The soft key copies the selected block into the buffer. The block
remains stored in the buffer even after the parts program has been
changed.
This soft key marks the block end and deletes the block in the
program. The deleted block is stored in the buffer.
This soft key inserts the deleted or copied block from the buffer to the
text behind the cursor position.
An NC block is deleted.
Specify the following values in the "Renumber" box:
• Increment for the block numbers (e.g. 1, 5, 10)
• Number of the first block
To remove the step numbering, set the increment or block number
to 0.
The soft key opens the "Search term" dialog box.
Enter the term you are searching for. You can set the search direction
forwards or backwards with the "Alternat." soft key.
Searches for the next of the term entered under "Search for" and
replaces it with the new term.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
7
08.02