Manual Offset - Siemens SINUMERIK 840DE Operation & Programming Manual

3
08.02

3.4.3 Manual offset

Precondition
Example
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Sequence of operations
You have started a cycle, elementary contour or EasyStep program.
1. Manual offset via handwheel
• Activate Handwheel key
• Traverse with handwheel
"Manual offs." appears in the status field to inform the operator that
a manual offset is active. The offset is included in the actual
position display.
Additional notes
Programmed absolute positions are traversed relative to the manual
offset.
• Straight line in Z programmed with:
Manual offset in Z active:
• At the beginning of the straight line
Actual position display, e.g.
Distance to go
• After the straight line has been traversed
Actual position display
Distance to go
2. Storing the manual offset via Offset
(see Section "Intervention in the Machining Process")
Preparatory Functions for Machining
3.4 Offsets
100mm (abs)
5mm
35mm (incl. manual offset)
70mm
105mm
0mm
3
3-49