Editing A Program; Overview - Program Editor - Siemens SINUMERIK 840D sl Operating Manual

Machine the workpiece

3.9 Editing a program

Deleting blocks
3.9 Editing a program
3.9.1

Overview - Program editor

With the editor, you are able to render, supplement, or change part programs.
Note
The maximum block length is 512 characters.
Calling the editor
● The editor is started via the "Program correction" function in the "Machine" operating
● The editor is called via the "Open" softkey as well as with the "INPUT" or "Cursor right"
● The editor opens in the "Program" operating area with the last executed part program,
Note
Please note that the changes to programs stored in the NC memory take immediate
effect. You can exit the editor only after you have saved the changes.
If you are editing on a local drive or external drives, you can also exit the editor without
saving, depending on the setting.
Exit the program correction mode using the "Close" softkey to return to the "Program
manager" operating area.
See also
Editor settings (Page 99)
Opening and closing a program (Page 179)
Correcting a program (Page 81)
94
Press the "Delete blocks" softkey to delete program blocks you have
entered.
area.
key in the "Program manager" operating area.
when this was not explicitly exited via the "Close" softkey.
Operating Manual, 01/2008, 6FC5398-6AP10-2BA0
HMI sl Universal