Siemens SINUMERIK 840DE Operation & Programming Manual page 90

5
Turning with Cycles
5.2 Turning cycles in CYCLE mode
Position (alternative)
Undercut size
X0, Z0
X1
Z1
V
5-90
Explanation of parameters
Form F undercut
This setting determines the position of the undercut in the coordinate
system.
Form F undercut
Z
X X
Z
X
X
Selection according to DIN table: Radius/depth, e.g. F0.6 x 0.3 (Form
F undercut). Can be set via the "Alternat." soft key.
Reference points for dimensioning
Allowance in X direction
Allowance in Z direction (for Form F undercut)
Cross-feed X
Form E undercut
Form E undercut
Z
X
Z
X
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
5
08.02
Z
Z
X
Z
Z
X