Contact Outputs; Virtual Outputs; Remote Devices - GE T35 Instruction Manual

6.2 STATUS
PATH: ACTUAL VALUES

# CONTACT OUTPUTS

#
The present state of the contact outputs is shown here. The first line of a message display indicates the ID of the contact
output. For example, 'Cont Op 1' refers to the contact output in terms of the default name-array index. The second line of
the display indicates the logic state of the contact output.
For Form-A outputs, the state of the voltage(V) and/or current(I) detectors will show as: Off, VOff, IOff, On,
VOn, and/or IOn. For Form-C outputs, the state will show as Off or On.
NOTE
PATH: ACTUAL VALUES

# VIRTUAL OUTPUTS

#
The present state of up to 64 virtual outputs is shown here. The first line of a message display indicates the ID of the virtual
output. For example, 'Virt Op 1' refers to the virtual output in terms of the default name-array index. The second line of the
display indicates the logic state of the virtual output, as calculated by the FlexLogic™ equation for that output.
6
a) STATUS
PATH: ACTUAL VALUES

# REMOTE DEVICES

# STATUS
The present state of up to 16 programmed Remote Devices is shown here. The
cates whether or not all programmed Remote Devices are online. If the corresponding state is "No", then at least one
required Remote Device is not online.
6-4
! !"
STATUS CONTACT OUTPUTS
Cont Op 1
Off
Cont Op xx
MESSAGE
Off
! !"
STATUS VIRTUAL OUTPUTS
Virt Op 1
Off
Virt Op 64
MESSAGE
Off
! !"
STATUS REMOTE DEVICES STATUS
All REMOTE DEVICES
ONLINE: No
REMOTE DEVICE
MESSAGE
STATUS: Offline
REMOTE DEVICE 16
MESSAGE
STATUS: Offline
T35 Transformer Management Relay
↓
↓
Range: Yes, No
Range: Online, Offline
1
↓
Range: Online, Offline
ALL REMOTE DEVICES ONLINE
6 ACTUAL VALUES
6.2.4 CONTACT OUTPUTS
6.2.5 VIRTUAL OUTPUTS
6.2.6 REMOTE DEVICES
message indi-
GE Multilin