Modbus User Map; Real Time Clock; User-Programmable Fault Report - GE T35 Instruction Manual

5 SETTINGS
!
PATH: SETTINGS PRODUCT SETUP

# MODBUS USER MAP

#
MESSAGE
The Modbus User Map provides read-only access for up to 256 registers. To obtain a memory map value, enter the desired
address in the line (this value must be converted from hex to decimal format). The corresponding value is dis-
ADDRESS
played in the line. A value of "0" in subsequent register
VALUE
lines incremented by "1". An address value of "0" in the initial register means "none" and values of "0" will be dis-
ADDRESS
played for all registers. Different
These settings can also be used with the DNP protocol. See the DNP Analog Input Points section in Appen-
dix E for details.
NOTE
!
PATH: SETTINGS PRODUCT SETUP
# REAL TIME
# CLOCK
MESSAGE
The date and time for the relay clock can be synchronized to other relays using an IRIG-B signal. It has the same accuracy
as an electronic watch, approximately ±1 minute per month. An IRIG-B signal may be connected to the relay to synchronize
the clock to a known time base and to other relays. If an IRIG-B signal is used, only the current year needs to be entered.
See also the !"
COMMANDS
The
REAL TIME CLOCK EVENTS
!
PATH: SETTINGS PRODUCT SETUP
# USER-PROGRAMMABLE
# FAULT REPORT 1
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
GE Multilin
!"
MODBUS USER MAP
ADDRESS 1:
VALUE: 0
↓
ADDRESS 256:
VALUE: 0
values can be entered as required in any of the register positions.
ADDRESS
!"

REAL TIME CLOCK

IRIG-B SIGNAL TYPE:
None
REAL TIME CLOCK
EVENTS: Disabled
menu for manually setting the relay clock.
SET DATE AND TIME
setting allows changes to the date and/or time to be captured in the event record.
!"

USER-PROGRAMMABLE FAULT REPORT

FAULT REPORT 1
FUNCTION: Disabled
PRE-FAULT 1 TRIGGER:
Off
FAULT 1 TRIGGER:
Off
FAULT REPORT 1 #1:
Off
FAULT REPORT 1 #2:
Off
↓
FAULT REPORT 1 #32:
Off
T35 Transformer Management Relay
Range: 0 to 65535 in steps of 1
0
Range: 0 to 65535 in steps of 1
0
lines automatically returns values for the previous
ADDRESS
Range: None, DC Shift, Amplitude Modulated
Range: Disabled, Enabled
5.2.7 USER-PROGRAMMABLE FAULT REPORT
!
USER-PROGRAMMABLE FAULT REPORT 1(2)
Range: Disabled, Enabled
Range: FlexLogic™ operand
Range: FlexLogic™ operand
Range: Off, any actual value analog parameter
Range: Off, any actual value analog parameter
Range: Off, any actual value analog parameter
5.2 PRODUCT SETUP
5.2.5 MODBUS USER MAP
5.2.6 REAL TIME CLOCK
5-19
5