After Replacingthe Control Board Orthe Control Module - GE Aespire 7100 Technical Reference Manual

Aespire 7100
8.2 After replacing the Control Board or the Control Module
8 -4
1. Load the appropriate so伽'are revision (Sec世on 8.3) using a software memory stick
that matches the 50筒ware revision ofthe replaced control board (control module).
2. Activate the appropriate options on the Upg，田de Optlons menu
(Section 4.11).
A. Ifthe original
con币guration
included all ofthe optional features
,
enterthe Key
Code supplied wi白白e replacement Control Board (Control Module) following
Stepsa. 由 rough d. , below.
B. If the original configuration included only some optional features , enter the
Replacement Control Board Key Code obtained from the Key Code Generator
web site , as follows.
a. Enter the Servlce Mode.
b. Select Upgtade Optlons.
c. Prior to installing the new Key Code , reset the options key by entering the
following key code: GOOOOOO.
d. Th en enterthe
approp阳te
Key Code to
resωre
the original Upgrade
Options.
3. On the
Sys
tem Co nflgu
l8
t/on menu
, reset 世le
configuration to match the settings
recorded in Section 8.1
4. If required
,
record the new (web site generated) Key Code on the label provided in
the replacement Control Board kit (or on the Control Module).
5. Affi 以 the label to the back ofthe display module as shown.
Replacement
Co
ntrol
Boa叫
08/07 Mll10140