GE Aespire 7100 Technical Reference Manual page 145

Mll10140 佣:/07
5 Calibration
20. Tum 由 e valve clockwiseω 由 eminimumsωp.
2 1. Verify there is no flow at the end of the tube.
22. Th oroughly clean the end ofthe nylon tube and reconnect
itωthe
vaporizer manifold inle
t.
23. After calibrating
minimum 刊owforN 2 0:
a. Close the cylindervalve and use the needle valve to bleed the
remaining gas.
b. Remove the test f
lXtU
re connecting the N
2
0 gas supply to pressure
balance regulator pilot port.
c. Reconnect the pilot tube to the N
2
0 pilot
po比 Pull
on the tubing to
ensure it is locked into the fitting.
Connect
d. Reconnectthe outlettube to the N
2
0 pipeline supply manifold.
24. Calibrate the Li nk proportioning system (Section 5 .4).
5-13