Table of Contents
Advertisement
7 Troubleshooting
Test
14
Testlng 恤e 饵owsenso阳 only
Note: To
ensure
a
air-tight
seal
,
use the corresponding
plug
as
iII
ustrated for the
original flow sensor (A)
orthene毗
moisture resistant
{。他et)
flow sensor (B).
M1110140ω107
1. Remove the Flow Sensor Module.
2. Plug each Row Sensor as shown above.
3. Connect the low-pressure leak test device to the open end of the Row Sensor.
4. Block the
connec'ωr
end of the Row Sensor with your hand.
5. Compress and release the bulb until it is empty.
6. Ifthe bulb inflates in 30 seconds or less , there is a leak in the flow sensor.
7. Ifthere are no
lea陆 in
the flow sensors , go
to
Test 15.
7-25
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
