GE Aespire 7100 Technical Reference Manual page 202

Aespire
7100
Message Alarmj
Err
or Cause User ActlonjConcems Servlce Repalr
No
Ex
p Flow Sensor UserAlarm Electrical signals show the Connect the flow sensors.
flow sensor is not Make sure the flow sensor
connected. module is on all the way.
No Insp Flow Sensor User Alarm Electrical signals show the Connect the flow sensors.
flow sensor is not Make sure the flow sensor
connected. module is on all the way.
No O
2
Pressure UserAlarm The O
2
supply has failed. Airflowwill continue. Ventilate
manually if
necessar如
Connect a pipeline supply or
install an O
2
cylinder.
O
2
Flush Failure UserAlarm The pressure switch that Th is alarm occurs if you hold If persists
,
check:
detects flush flow has down the Flush button for
• O
2
flush switch
seen a very long flush more than 30 seconds.
• Cable to SICB
(注30 sec).
• SICB
• Cable
ωCB/J11
O
2
Sensor Out of Circ User Alarm O
2
sensor not installed in Install a breathing circuit module
breathing circuit module.
and an O
2
sensor.
Sensor not measuring gas in
breathing circui
t.
O
2
Mon Disabled UserAlarm An Oxygen cell has been
Th e Oxygen Monitoring feature is Service Mode:
connected to a non- not active on this system.
• System
active ventilator
Con自 gurations
monitoring feature.
On Battery- UserAlarm The mains supply is not Ventilate manually to save
PowerOK? connected or has failed power.
and the system is using At full charge
,
the
ba忧ery
ba吐ery power. permits approximately
30 minutes of mechanical
ventilation.
Make sure power is connected
and circuit breakers are
closed. Check the ventilator
fuse.
Patient Circuit Leak? User Alarm
Ex
haled volume <50% of Check breathing circuit and flow
inspired volume for at sensor connections.
least 30 seconds
Patient circuit leak audio can be
(mechanical ventilation). turned off in the Alarm
Settings menu.
7-36
08/07 Mll10140