Completing A Configuration; Line Card Commands - Cisco 10000 Series Configuration Manual

Line Card Commands

To enable ILMI, perform the following steps:
Create PVC 0/16 on the main interface as shown in the following example:
Step 1
Router(config)# interface atm 5/0/0
Router(config-if)# pvc 0/16 ilmi
Router(config-if-atm-vc)# exit
Router(config-if)#
Enable ILMI PVC discovery for the selected port (step 1 references port 0).
Step 2
Router(config-if)# atm ilmi-pvc-discovery
You have completed the steps required to run ILMI PVC discovery. You can use the show atm pvc
command to display the PVCs on the Cisco 10000 series router.

Completing a Configuration

This section offers general information on creating and completing a configuration of an 8-Port E3/DS3
ATM line card.
To configure an interface, perform the following steps:
Enter interface configuration mode and specify necessary parameters, such as the IP address and subnet
Step 1
mask.
After you enter all of the commands to complete the configuration, press Ctrl-Z (hold down the Control
Step 2
key while you press Z) to exit configuration mode.
Write the new configuration to memory:
Step 3
Router# copy running-config startup-config
The system displays an OK message when the configuration is stored.
To check your completed configuration, use the show commands. For more information about show
commands, see
Line Card Commands
The 8-Port E3/DS3 ATM line card allows you to specify eight E3 or eight T3 interfaces. You can put all
the PVCs on the interfaces, or you can create associated subinterfaces. This section describes the
principal commands for customizing interfaces and PVCs:
•
•
•
•
Cisco 10000 Series Router Line Card Configuaration Guide
2-6
Useful show Commands, page
Global Configuration Commands, page 2-7
ATM Interface and Subinterface Commands, page 2-7
ATM PVC Commands, page 2-16
Useful show Commands, page 2-21
Chapter 2 8-Port E3/DS3 ATM Line Card Configuration
2-21.
OL-8834-04