Cisco 10000 Series Configuration Manual page 196

SDH-Framed Interface Configuration Sample
For AU-4-TUG-3, the command to display the settings for TUG-3 #3 on AU-4 of a 4-Port Channelized
OC-3/STM-1 line card in slot 2 is:
show controller au-4-tug-3 2/0/0.1/3
To display a specific TUG-2 and E1 on the same AU-4-TUG-3, use the command:
show controller au-4-tug-3 2/0/0-1/3/1/3
AU-3 Controller Interfaces
Use the following procedure to create T3 and T1 interfaces using AU-3 controllers.
Enter SONET controller configuration mode from global configuration mode.
Step 1
In this example, the 4-port STM-1 line card is in slot 1.
Router(config)# controller sonet 2/0/0
Router(config-controller)#
Step 2 Use the aug controller command to specify the mode of operation for an OC-3/STM-1 port (for an
AU-3, twelve controllers are created:
Router(config-controller)# aug controller au-3
Router(config-controller)#
Full-Rate T3 Interface
Note
a.
b.
T1 Channel Group Interface
a.
b.
c.
Cisco 10000 Series Router Line Card Configuaration Guide
7-12
T3 lines can only operate over AU-3 controllers.
Configure the controller on the port.
This example shows AU-3 controller #3 configured for a line card in slot 2.
Router(config-controller)# controller au-3 2/0/0.3
Router(config-controller)#
Set the container mode to C-3 to establish a T3 interface.
Router(config-controller)# mode c-3
Router(config-controller)# exit
Router(config)#
C-3 mode creates a serial interface at the unchannelized T3 level.
Configure the controller on the STM-1 port.
This example shows AU-3 controller #2 configured on the STM-1 port for a line card in slot 2.
Router(config)# controller au-3 2/0/0.2
Router(config-controller)#
Set the container mode to C-11 to establish a T1 interface.
Router(config-controller)# mode c-11
Router(config-controller)#
Create a T1 interface.
Chapter 7 4-Port Channelized OC-3/STM-1 Line Card Configuration
).
2/0/0.1 to 2/0/0.12
OL-8834-04