Software Support; Checking Hardware And Software Compatibility - Cisco 10000 Series Configuration Manual

8-Port E3/DS3 ATM Line Card Configuration
This chapter describes procedures for configuring the Cisco 10000 series 8-Port E3/DS3 ATM line card,
hereafter known as the 8-Port E3/DS3 ATM line card.
The 8-Port E3/DS3 ATM line card has eight E3 or DS3 (T3) copper interface terminations that provide
Asynchronous Transfer Mode (ATM) serial interfaces and perform Layer 2 ATM functions.
This chapter contains the following sections:
•
•
•
•
•
•

Software Support

Table 2-1
ATM line card.
Table 2-1
Required PRE
PRE2

Checking Hardware and Software Compatibility

The PRE installed in the Cisco 10000 series router chassis must support the Cisco IOS software running
on the router. Use the show version command to check the PRE version installed.
To see if a feature is supported by a Cisco IOS release, to locate the software document for that feature,
or to check the minimum software requirements of Cisco IOS software with the hardware installed on
your router, Cisco maintains the Software Advisor tool on Cisco.com at
http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl
OL-8834-04
Software Support, page 2-1
Default Values, page 2-2
Line Card VC Limitations, page 2-2
Interface Syntax, page 2-3
Line Card Interface Configuration Examples, page 2-4
Line Card Commands, page 2-6
shows the minimum Cisco IOS release on each release train that supports the 8-Port E3/DS3
8-Port E3/DS3 ATM Line Card Software Support
Minimum Cisco IOS Releases
Cisco IOS Release 12.2(16)BX and later releases of Cisco IOS Release 12.2BX
Cisco IOS Release 12.3(7)XI and later releases of Cisco IOS Release 12.3XI
Cisco IOS Release 12.2(28)SB and later releases of Cisco IOS 12.2SB
C H A P T E R
Cisco 10000 Series Router Line Card Configuaration Guide
2
2-1