Setting The Line Card Framing - Cisco 10000 Series Configuration Manual

Chapter 2 8-Port E3/DS3 ATM Line Card Configuration
Router(config-if-atm-vc)#end

Setting the Line Card Framing

The 8-Port E3/DS3 ATM line card supports ADM and PLCP framing on E3 and T3 connections. The
following sections describe how to set T3 ADM, T3 PLCP, E3 ADM, and E3 PLCP framing.
Setting T3 ADM Framing
If you configured the 8-Port E3/DS3 ATM line card for T3 ADM using the atm dsx3mode ds3 adm
command, configure the framing using the atm framing command in interface configuration mode.
[no] atm framing {cbitadm | m23adm}
Where:
cbitadm is C-bit ADM T3 Framing
m23adm is M23 ADM T3 Framing
The default is cbitadm.
In the following example, M23 ADM T3 framing is set:
Router(config)# interface atm 2/0/0
Router(config-if)# atm framing m23adm
Setting T3 PLCP Framing
If you configured the 8-Port E3/DS3 ATM line card for T3 PLCP using the atm dsx3mode ds3 plcp
command, configure the framing using the atm framing command from interface configuration mode.
[no] atm framing {cbitplcp | m23plcp}
Where:
cbitplcp is C-bit PLCP T3 Framing
m23plcp is M23 PLCP T3 Framing
The default cbitplcp
In the following example, C-bit PLCP T3 framing is set:
Router(config)# interface atm 2/0/0
Router(config-if) atm framing cbitplcp
Setting E3 ADM Framing
If you configured the 8-Port E3/DS3 ATM line card for E3 ADM using the atm dsx3mode e3 adm
command, configure the framing using the atm framing command in interface configuration mode.
[no] atm framing {g751adm | g832adm}
Where:
g751adm is G.751 ADM E3 framing
g832adm is G.832 ADM E3 framing
The default is g751adm.
In the following example, G.751 ADM E3 framing is set:
Router(config)# interface atm 2/0/0
OL-8834-04
Cisco 10000 Series Router Line Card Configuaration Guide
Line Card Commands
2-9