Cisco 10000 Series Configuration Manual page 269

Chapter 13 1-Port OC-12 Packet over SONET Line Card Configuration
Interface Syntax
To specify an interface number in a configuration command, use the syntax in
interfaces on the 1-Port OC-12 Packet over SONET line card.
Table 13-3 1-Port OC-12 Packet over SONET Interface Syntax
Type of Interface
Packet over SONET interface
The following example shows the syntax for configuring an 1-Port OC-12 Packet over SONET line card
in slot 1:
Router(config)# interface pos 1/0/0
Configuring the Interface
After you verify that the 1-Port OC-12 Packet over SONET line card is installed correctly, use the
following procedure to configure the new interface. Be prepared with necessary information, such as the
interface IP address.
Use the following procedure to create a basic configuration—enabling an interface and specifying IP
routing.
At the global configuration prompt, specify the new interface to configure by entering the interface pos
Step 1
command and interface address. For example:
Router(config)# interface pos 1/0/0
Assign an IP address and a subnet mask to the interface with the ip address configuration subcommand,
Step 2
as in the following example:
Router(config-if)# ip address 192.168.255.255 255.255.255.0
Specify either HDLC or PPP encapsulation. For example:
Step 3
Router(config-if)# encapsulation hdlc
If necessary, modify the 1-Port OC-12 Packet over SONET line card configuration or that of the remote
Step 4
device to ensure that, where appropriate, they use the same settings. For more information, refer to the
Remote Side Setting column in
Step 5 Add any other configuration subcommands required for the enabling of routing protocols and adjust the
interface characteristics.
Step 6 Enter the no shutdown command to enable the interface.
Router(config-if)# no shutdown
Step 7 When you have included all of the configuration subcommands to complete the configuration, enter
Crtl-Z to exit configuration mode.
Write the new configuration to memory.
Step 8
Router# copy running-config startup-config
OL-8834-04
Slot Subslot
1 to 8/ 0/
Table 13-2.
Cisco 10000 Series Router Line Card Configuaration Guide
Interface Syntax
Table 13-3
Port
0
to identify
13-3