Specifying The Atm Flag; Specifying The Atm Ilmi Keepalive Rate - Cisco 10000 Series Configuration Manual

ATM Commands
Where:
•
Note
The following example shows how to enable PVC discovery on the ATM main interface 7/0/0, for port
0, on a 4-Port OC-3/STM-1 ATM line card that has ILMI enabled.
Router(config)# interface atm 7/0/0
Router(config-if)# pvc 0/16 ilmi
Router(config-if-atm-vc)# exit
Router(config-if)# atm ilmi-pvc-discovery

Specifying the ATM ILMI Keepalive Rate

Use the atm ilmi-keepalive command to specify the ILMI keepalive rate.
atm ilmi-keepalive [seconds [retry counts]]
Where:
•
•
The default value for seconds is 5000 and for retry counts is 4.
The following example shows how to enable ILMI keepalives for the ATM interface 5/0/0:
Router(config)# interface atm 5/0/0
Router(config-if)# atm ilmi-keepalive 10000 retry 3
Configuring the ATM Clock
Use the atm clock internal command to configure the clock source as internal.
atm clock internal
no atm clock internal
The default clock setting is no atm clock internal, which means that clocking is derived from the line.
In the following example, clocking is set from the router.
Router(config)# interface atm 5/0/0
Router(config-if)# atm clock internal

Specifying the ATM Flag

This command is typically used to meet a standards requirement or to ensure interoperability with
another vendor's equipment. Use the atm flag s1s0 command to specify the ATM flag value for the s1and
s0 bits.
atm flag s1s0 value
Cisco 10000 Series Router Line Card Configuaration Guide
1-12
subinterface instructs the software to associate all PVCs with existing subinterface numbers equal
to their VPI numbers. For example: PVC 2/102 would be listed under subinterface 7/0/0.2, PVC
12/156 would be listed under 7/0/0.12, and so on.
The subinterface argument associates PVCs only with subinterfaces that have already been
created. If there is no subinterface for a VPI value, the system associates the PVC with the main
interface.
seconds is a value from 1 to 65535
retry counts is a value from 2 to 5
Chapter 1 4-Port OC-3/STM-1 ATM Line Card Configuration
OL-8834-04