Management Port - Cisco 10000 Series Configuration Manual

Default Values
Checking Hardware and Software Compatibility
The PRE installed in the Cisco 10000 series router chassis must support the Cisco IOS software running
on the router. Use the show version command to check the PRE version installed.
To see if a feature is supported by a Cisco IOS release, to locate the software document for that feature,
or to check the minimum software requirements of Cisco IOS software with the hardware installed on
your router, Cisco maintains the Software Advisor tool on Cisco.com at
http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl
This tool does not verify whether line cards within a system are compatible, but does provide the
minimum Cisco IOS requirements for individual hardware line cards, modules, or options.
You must be a registered user on Cisco.com to access this tool.
Default Values
Table 9-2
Table 9-2
Parameter Default Setting
Speed
Duplex

Management Port

The Fast Ethernet interface 0/0/0 is reserved for management purposes only and cannot be used for such
things as customer traffic or L2TP establishment. This interface also does not allow you to configure
subinterfaces. However, the interface does allow radius, snmp, or telnet commands.
Cisco 10000 Series Router Line Card Configuaration Guide
9-2
lists default values for the 8-Port Fast Ethernet Half-Height line card.
8-Port Fast Ethernet Half-Height Line Card Defaults
Description
100 Mbps You cannot use the speed command. The speed
is advertised as 100 Mbps to the remote device.
Autonegotiated See the
section on page 9-4
value.
Note
Chapter 9 8-Port Fast Ethernet Half-Height Line Card Configuration
"Specifying Full or Half Duplex Mode"
to manually set the duplex
The Fast Ethernet line card only
responds to 802.3x pause frames from
another device when it autonegatiates
the duplex mode (the default). The line
card does not support 802.3x flow
control when you manually set
half-duplex or full-duplex mode.
OL-8834-04