Completing The Configuration; Using The Cisco Ios-Xe Cli-Manual Configuration - Cisco ASR 1001-X Installation Manual

Chapter 5 Cisco ASR 1001-X Router Power Up and Initial Configuration

Completing the Configuration

When using the Cisco setup command facility, and after you have provided all the information requested
by the facility as described in
configuration appears. To complete your router configuration, follow these steps:
The facility prompts you to save the configuration.
Step 1
•
•
Use this configuration? {yes/no} : yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
%LINK-3-UPDOWN: Interface GigabitEthernet0/1/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1/0, changed state to up
<Additional messages omitted.>
When messages stop appearing on your screen, press Return to get the Router> prompt.
Step 2
The Router> prompt indicates that you are now at the command-line interface (CLI) and you have just
Step 3
completed an initial router configuration. Note that this is not a complete configuration. At this point,
you have two choices:
•
•
Using the Cisco IOS-XE CLI—Manual Configuration
This section shows you how to access the CLI to perform the initial configuration on the router.
If the system configuration message does not appear, it means a default configuration file was installed
on the router prior to shipping. Follow these steps to configure the router.
Enter no when the following system message appears on the router:
Step 1
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Press Return and continue with the manual configuration:
Step 2
OL-32376-02
"Using the Cisco setup Command Facility" section on page
If you answer no, the configuration information you entered is not saved, and you return to the router
enable prompt (Router#). Enter setup to return to the System Configuration dialog box.
If you answer yes, the configuration is saved, and you are returned to the user EXEC prompt
(Router>).
Run the setup command facility again, and create another configuration:
Router> enable
Password: password
Router# setup
Modify the existing configuration or configure additional features by using the CLI:
Router> enable
Password: password
Router# configure terminal
Router(config)#
Performing the Initial Configuration on the Router
Cisco ASR 1001-X Router Hardware Installation Guide
5-4, the final
5-7