Shutting Down Line Card Simulation - Cisco 10000 Series Configuration Manual

Command Descriptions
The following relationships exist between the Cisco series 10000 router on-line insertion (OIR) feature
and the card command:
•
Note

Shutting Down Line Card Simulation

You use this command to turn on and shut down simulated 24-Port Channelized E1/T1 line card
operation using the following syntax:
Router (config)#[no] hw-module {slot slot shutdown | subslot subslot/slot shutdown}
The following examples show how you use the hw-module shutdown command to shut down or turn on
the E1/T1 line-card simulated running configuration:
•
•
Configuring a Controller
You use the configure terminal command to enter the global configuration mode and to configure the
E1 or T1 controller. To select a chassis slot, subslot, and port E1 controller, you use the following syntax
from the global configuration mode:
Router(config)# controller {t1 | e1} slot/subslot/port
Cisco 10000 Series Router Line Card Configuaration Guide
5-16
– When you install a 24-Port Channelized E1/T1 line card into a router chassis slot for which a
24che1t1-1 entry already exists in the running configuration, the OIR feature invokes the
existing E1 or T1 controller configuration.
When you install a 24-Port Channelized E1/T1 line card into a router chassis slot for which no
–
24che1t1-1 entry exists in the running configuration, the OIR feature invokes the default
configuration.
When you install a 24-Port Channelized E1/T1 line card into a router chassis slot for which a
–
product reference other than 24che1t1-1 exists, the OIR feature invokes the default
configuration.
In this example you simulate the removal of a 24-Port Channelized E1/T1 line card from router
chassis slot 3, which you previously specified with the card command.
To use the "no" form of card command, the line card must be physically removed from the
chassis.
Router(config)# hw-module slot 3 shutdown
Router(config)# no card 3/0
Router(config)#
In this example, you shut down a simulated running configuration in router chassis slot 5:
Router(config)# hw-module slot 5 shutdown
Router(config)#
In this example, you turn on the simulated running configuration of the line card in router chassis
slot 5:
Router(config)# no hw-module slot 5 shutdown
Router(config)#
Chapter 5 24-Port Channelized E1/T1 Line Card Configuration
OL-8834-04