Cisco 10000 Series Configuration Manual page 67

1-Port OC-12 ATM Line Card Configuration
This chapter describes procedures for configuring the Cisco 10000 series 1-Port OC-12 ATM line card,
hereafter known as the 1-Port OC-12 ATM line card.
The 1-Port OC-12 ATM line card is a trunk uplink for the Cisco 10000series routers that provides IP
packet routing over ATM virtual circuit connections using a single-mode fiber intermediate reach SC
connector.
This chapter contains the following sections:
•
•
•
•
•
•
Software Support
Table 3-1
ATM line card.
Table 3-1
Required PRE
PRE1
PRE2
PRE3
OL-8834-04
Software Support, page 3-1
Default Values, page 3-2
Line Card VC Limitations, page 3-2
Interface Syntax, page 3-4
Interface Configuration Samples, page 3-4
Commands, page 3-7
shows the minimum Cisco IOS release on each release train that supports the 1-Port OC-12
1-Port OC-12 ATM Line Card Software Support
Minimum Cisco IOS Releases
Cisco IOS Release 12.0(22)S and later releases of Cisco IOS Release 12.0S
Cisco IOS Release 12.0(10)SL and later releases of Cisco IOS Release 12.0SL
Cisco IOS Release 12.0(22)S and later releases of Cisco IOS Release 12.0S
Cisco IOS Release 12.3(7)XI and later releases of Cisco IOS 12.3XI
Cisco IOS Release 12.2(28)SB and later releases of Cisco IOS 12.2SB
Cisco IOS Release 12.2(31)SB2 and later releases of Cisco IOS 12.2SB
C H A P T E R
Cisco 10000 Series Router Line Card Configuaration Guide
3
3-1