Show Controller Command Syntax - Cisco 10000 Series Configuration Manual

Chapter 6 1-Port Channelized OC-12/STM-4 Line Card Configuration
The SONET controller command specifies the mode, and creates three [sub]controllers of that type,
which you can configure like any other controller.
The format created adds a subport extension to the controller SONET name. The form of the subport
extension is different for AU-3 and AU-4-TUG-3 controllers as the following examples show:
AU-3 Controller Syntax
controller au-3 <slot>/<subslot>/<port>.<AU-3#>
For example, the controller command for AU-3 #3 on port 0 of a 4 -port channelized STM-1 line card in
slot 2 is:
controller au-3 2/0/0.3
AU-4-TUG-3 Controller Syntax
controller au-4-tug-3 <slot>/<subslot>/<port>.<AU-4#>/<TUG-3#>
For example, the command for a controller created for TUG-3 #3 on AU-4 of port 0 of a 1-Port Channelized
OC-12/STM-4 line card in slot 2 is:
controller au-4-tug-3 2/0/0.1/3

Show Controller Command Syntax

To display the settings for specific on AU-3 and AU-4-TUG-3 controllers, use the show controller
command.
For AU-3:
show controller au-3 <slot>/<subslot>/<port>.<AU-3#>[/<tug-2>/<t1>]
For AU-4-TUG-3:
show controller au-4-tug-3
<slot>/<subslot>/<port>.<AU-4#>/<TUG-3#>[/<tug-2>/<t1 or e1>]
Where:
•
•
•
•
•
•
•
•
OL-8834-04
AU-3 and AU-4-TUG-3s are based on the higher order path, and do not operate
Note
independently, but operate in groups of three. If you shutdown any AU-3 or AU-4-TUG-3
controller, the other two controllers on the same SONET port are also shut down.
slot is 1 to 8
subslot is 0
port is always 0
AU-3# is 1 to 12
AU-4# is always 1
TUG-3# is 1 to 12
tug-2 is 1 to 7
t1 is 1 to 4 or e1 is 1 to 3
SDH-Framed Interface Configuration Sample
Cisco 10000 Series Router Line Card Configuaration Guide
6-11