Line Card Default Values For Sdh Framing - Cisco 10000 Series Configuration Manual

Line Card Default Values
Table 6-7
Command Name
t1 clock source
t1 framing
e1 clock source
e1 framing

Line Card Default Values for SDH Framing

This section contains tables of command default values that apply when the 1-Port Channelized
OC-12/STM-4 line card is configured for SDH framing.
Table 6-8
mode when the 1-Port Channelized OC-12/STM-4 line card is configured for SDH framing.
Table 6-9
for both AU-3 and AU-4-TUG-3 when the 1-Port Channelized OC-12/STM-4 line card is configured for
SDH framing.
Table 6-10
card is configured for SDH framing.
Table 6-11
card is configured for either SONET or SDH framing.
Table 6-8
Command Name
SONET Controller Configuration Mode under SDH
clock source
framing
loopback
overhead
aug controller
1. The default value for SDH clock source is line. At least one side of the connection must be set to internal.
Cisco 10000 Series Router Line Card Configuaration Guide
6-6
Default Values for T1 and E1 Configuration Commands under SONET Framing
Default
Setting Command Syntax
internal
t1 ch_group_number clock source
{line | internal}
esf
t1 t1-number framing {esf | sf}
internal
e1 ch_group_number clock source
{line |internal}
crc4
e1 e1-number framing [crc4 | no-crc4]
lists the default values for commands that are available in SONET controller configuration
lists the default values for commands that are available in AU-3 controller configuration mode
lists the default values for T3 commands when the 1-Port Channelized OC-12/STM-4 line
lists default values for T1 and E1 commands when the 1-Port Channelized OC-12/STM-4 line
Default Values for SONET Controller Configuration Commands under SDH Framing
Default Setting
1
line
sonet
no loopback
1 for j0
2 for S1S0
no aug controller
Chapter 6 1-Port Channelized OC-12/STM-4 Line Card Configuration
Command Syntax
[no] clock source {internal|line}
framing {sonet | sdh}
[no] loopback {internal | line}
overhead {j0 | s1s0}
[no] aug controller <au-3|au-4-tug-3>
Remote Side
Setting
One side set to
internal
Same
One side set to
internal
Same
Remote Side
Setting
One side set
to internal
Same
—
—
—
OL-8834-04