Line Card Default Values - Cisco 10000 Series Configuration Manual

Line Card Default Values

Table 6-3
Interface Type
STM-4,
over STM-1
over AU-3,
over TUG-2,
over C-12 (E1)
STM-4,
over STM-1
over AU-4,
over TUG-3,
over TUG-2,
over C-11 (DS1/T1)
STM-4,
over STM-1
over AU-4,
over TUG-3,
over TUG-2,
over C-12 (E1)
Line Card Default Values
The 1-Port Channelized OC-12/STM-4 line card has two sets of command default values. The set of
default values in use is determined by the framing command—either SONET framing or SDH framing.
The following tables contains command default values, and indicate which configuration mode you need
to be in to enter a command. Where applicable, the tables also indicate which commands apply to which
line types. The tables include the commands used for modifying a default value and indicates whether a
value needs to be the same (or opposite) on the remote end of the connection.
Line Card Default Values for SONET Framing
This section contains tables of command default values that apply when the 1-Port Channelized
OC-12/STM-4 line card is configured for SONET framing.
Table 6-4
mode when the 1-Port Channelized OC-12/STM-4 line card is configured for SONET framing.
Table 6-5
when the 1-Port Channelized OC-12/STM-4 line card is configured for SONET framing.
Table 6-7
under a T3 controller, when the 1-Port Channelized OC-12/STM-4 line card is configured for SONET
framing.
Table 6-6
when the 1-Port Channelized OC-12/STM-4 line card is configured for SONET framing.
Cisco 10000 Series Router Line Card Configuaration Guide
6-4
SDH Interface Examples for an SDH-Framed Controller (continued)
Syntax
Router(config)# interface serial
<slot>/<subslot>/<port>.<AU-3#>/<TUG-2>/<C-12>:[chan]
Router(config)# interface serial
<slot>/<subslot>/<port>.<AU-4#>/<TUG-3>/<TUG-2>/<C-11>:[chan
Router(config)# interface serial
<slot>/<subslot>/<port>.<AU-4#>/<TUG-3>/<TUG-2>/<C-12>:[chan]
lists the default values for commands that are available in SONET controller configuration
lists the default values for commands that are available in T3 controller configuration mode
lists the default values for commands that are available in T1 controller configuration mode,
lists the default values for commands that are available in VT controller configuration mode
Chapter 6 1-Port Channelized OC-12/STM-4 Line Card Configuration
OL-8834-04