Configuring the Router
Verifying the Initial Configuration
Verify that the new interfaces are operating correctly by performing the following tests:
•
•
•
When you have completed and verified the initial configuration, your Cisco router is ready to configure
for specific functions. See the
about locating documentation for advanced configuration procedures.
Completing the Configuration
When you have completed and verified the initial configuration, your Cisco router is ready to configure
for specific functions.
Cisco IAD2801 Series Integrated Access Devices Hardware Installation Guide
6-8
To verify that the interfaces are operating correctly and that the interfaces and line protocol are in
the correct state—up or down—enter the show interfaces command.
To display a summary status of the interfaces configured for IP, enter the show ip interface brief
command.
To verify that you configured the correct hostname and password, enter the show configuration
command.
Chapter 6
"Completing the Configuration" section on page 6-8
Power Up and Initial Configuration Procedures
for information
OL-12433-01