Other Configuration Commands - Cisco 10000 Series Configuration Manual

1-Port OC-12 Packet over SONET Line Card
Configuration
This chapter describes procedures for configuring the Cisco 10000 series 1-Port OC-12 Packet over
SONET line card, hereafter known as the 1-Port OC-12 Packet over SONET line card.
The 1-Port OC-12 Packet over SONET line card provides a trunk uplink that supports up to 622 Mbps
throughput over a standard SONET/ITU-T Synchronous Digital Hierarchy (SDH) interface using a
single-mode fiber intermediate-reach SC connector.
This chapter contains the following sections:
•
•
•
•
•
Software Support
Table 13-1
Packet over SONET line card.
Table 13-1
Required PRE
PRE1
PRE2
OL-8834-04
Software Support, page 13-1
Default Values, page 13-2
Interface Syntax, page 13-3
Configuring the Interface, page 13-3
Other Configuration Commands, page 13-4
shows the minimum Cisco IOS release on each release train that supports the 1-Port OC-12
1-Port OC-12 Packet over SONET Line Card Software Support
Minimum Cisco IOS Releases
Cisco IOS Release 12.0(22)S and later releases of Cisco IOS 12.0S
Cisco IOS Release 12.0(22)S and later releases of Cisco IOS 12. 0S
Cisco IOS Release 12.3(7)XI and later releases of Cisco IOS 12.3XI
Cisco IOS Release 12.2(28)SB and later releases of Cisco IOS 12.2SB
C H A P T E R
Cisco 10000 Series Router Line Card Configuaration Guide
13
13-1