Au-3 Controller Interfaces - Cisco 10000 Series Configuration Manual

SDH-Framed Interface Configuration Sample
The [/<tug-2>/<t1>] options are only available if a mode (C-11 or C-12) is configured on the controller.
Note
For example, for T1 over AU-3, the command to display the settings for AU-3 #3 for a line card in slot
2 is:
show controller au-3 2/0/0.3
For AU-4-TUG-3, the command to display the settings for TUG-3 #3 on AU-4 of a 1-Port Channelized
OC-12/STM-4 line card in slot 2 is:
show controller au-4-tug-3 2/0/0.1/3
To display a specific TUG-2 and E1 on the same AU-4-TUG-3, use the command:
show controller au-4-tug-3 2/0/0-1/3/1/3

AU-3 Controller Interfaces

Use the following procedure to create T3 and T1 interfaces using AU-3 controllers.
Enter SONET controller configuration mode from global configuration mode.
Step 1
In this example, the 1-Port Channelized OC-12/STM-4 line card is in slot 1.
Router(config)# controller sonet 2/0/0
Router(config-controller)#
Step 2 Use the aug controller command to specify the mode of operation for an STM-4 port (for an AU-3,
twelve controllers are created:
Router(config-controller)# aug controller au-3
Router(config-controller)#
Full-Rate T3 Interface
Note
a.
b.
Cisco 10000 Series Router Line Card Configuaration Guide
6-12
T3 lines can only operate over AU-3 controllers.
Configure the controller on the port.
This example shows AU-3 controller #3 configured for a line card in slot 2.
Router(config-controller)# controller au-3 2/0/0.3
Router(config-controller)#
Set the container mode to C-3 to establish a T3 interface.
Router(config-controller)# mode c-3
Router(config-controller)# exit
Router(config)#
C-3 mode creates a serial interface at the unchannelized T3 level.
Chapter 6 1-Port Channelized OC-12/STM-4 Line Card Configuration
).
2/0/0.1 to 2/0/0.12
OL-8834-04