Sdcc Interface Configuration Commands - Cisco 10000 Series Configuration Manual

Chapter 14 1-Port OC-48/STM-16 Packet over SONET Line Card Configuration

SDCC Interface Configuration Commands

This section lists the commands that are available when you configure a SONET Section Data
Communications Channel (SDCC) interface on the router.
The SDCC interface is available only after the MAC protocol has been set to Packet over SONET. For
Note
more information about setting the MAC protocol, see the
page 14-4
Enabling the SDCC Interface Configuration Mode
You must first enable the SDCC interface configuration mode before attempting to configure any SDCC
commands. You can enable the SDCC interface mode from global configuration mode by using the sdcc
enable command.
sdcc enable
[no] sdcc enable
The default setting is disabled.
In the following example, SDCC is enabled:
Router(config)# sdcc enable
If you enter the no sdcc enable command after configuring an SDCC interface, the interface is removed
Caution
from the interface list in the configuration.
Enabling an SDCC Interface
You can administratively enable an SDCC interface using the no shutdown command.
shutdown
[no] shutdown
The default state of an SDCC interface is administratively up.
In the following example, an SDCC interface is enabled:
Router(config)# no shutdown
Interface Selection Command
To configure an SDCC interface, you must select an interface using the interface command:
interface sdcc slot/subslot/port
Where slot is 1 to 8, subslot is 0, and port is 0.
The following example shows how you specify an SDCC interface for a card in slot 2:
Router(config)# interface sdcc 2/0/0
Router(config-if)#
OL-8834-04
SDCC Interface Configuration Commands
MAC Protocol Selection Command,
Cisco 10000 Series Router Line Card Configuaration Guide
14-5