Command Descriptions; Privileged Exec Commands - Cisco 10000 Series Configuration Manual

Command Descriptions

Add any other configuration commands required to enable other routing protocols and to set other
Step 6
interface characteristics.
Be sure all physical port connections have been made on the line card in the Cisco series 10000 router
Step 7
chassis (see the
Step 8 When you have entered all of the necessary interface configuration commands (see the
Interface and Hardware Component Configuration Guide
return to the privileged EXEC mode.
Router(config-if)# end
Router#
Write the new configuration to NVRAM:
Step 9
Router# copy running-config startup-config
Router#
After you create the port interface configurations, you can modify them at any time using the appropriate
Cisco IOS commands described in the following sections and in the
Component Configuration Guide
Command Descriptions
You invoke the various IOS commands using the following Cisco IOS command modes (see
on page
•
•
•
•
You must begin configuring the 24-Port Channelized E1/T1 line card from the privileged EXEC
command mode.

Privileged EXEC Commands

The Cisco IOS privileged EXEC mode commands are:
•
•
•
You enter the privileged EXEC configuration mode from the user EXEC mode:
Router> enable
Password: (you enter your administrative password)
Router#
When your prompt changes to
Cisco 10000 Series Router Line Card Configuaration Guide
5-12
Cisco 10000 Series Router Line Card Hardware Installation
5-2):
Privileged EXEC
Global Configuration
Controller Configuration
Interface Configuration
hw-module
show controllers
show interfaces
Chapter 5
and the Cisco IOS Command
you are in the privileged EXEC mode.
Router#
24-Port Channelized E1/T1 Line Card Configuration
Guide).
publication), to complete the configuration,
Cisco IOS Interface and Hardware
References.
Cisco IOS
Table 5-2
OL-8834-04